|
| |
 | PCF1 - Single Repeater
Controller (Drop only) Microprocessor operated |
| PCF2 - Dual Controller
(Link/Drop) - Piggy pack board for 2nd repeater |
| PCF3 - Triple Controller
(Link/Drop/Link) - Piggy pack board for 2 & 3 repeaters |
| PCF4 - Digital Controller
for either Single or Link/Drop Dual Repeater Systems. |
Basic Controller Overview
| PCF1, PCF2 & PCF3 Repeater Controllers |
Features:
- Programmable configurations with PC Serial Port
- DTMF regeneration
- Site Alarm & Site Feature Interrogation
- A/D and Analog Inputs
- Battery Voltage Monitoring and low voltage alarm
- Multi-Ctcss or single Ctcss (drops or links)
- Programmable Courtesy Beep
- Programmable TOT and Hang Timers
- Transmit Level Adjustments for Voice, DTMF & Ctcss
- LED defeat switch
| PCF4 Repeater Controller |
Features:
- Lower Cost digital controller
- Used with Single Repeater operation or dual Link/Drop Repeaters
- Ctcss Ability (single Ctcss tone on a normal repeater and dual
or single Ctcss tones for link/drop repeaters)
- Front Access to Transmit Level Adjustments and Hang Timer
Adjustments
- Five (5) Minute or Ten (10) Minute Time-Out-Timer Selection
- Low Current Draw (1 mA)
- Repeater LED Disable Switch. The disable switch allows for lower
current operation by disabling the Power, Cos and Ptt LEDs on controller, Receiver
and Transmitter Modules.
- Field Repairable if necessary
Special Note: This controller does NOT have
DTMF Regeneration, Multi Ctcss inputs, Remote Site Alarm, Low Battery Alarm or any of the
programmable features of the PCF1 controller. This controller provides a substantial
reduction in costs to the tuWolf Repeater. If your customer does not require the
features of the PCF1/2/3, then the PCF4 controller is the one you should use.
Remember the PCF4 can be used for single repeaters or a link/drop application without
using the PCF2.
If you have any questions, please contact us at 1-800-811-0388
|
